Active Automation (NZ)
Product work from Active Automation in NZ
EV Conversion - Land Rover flywheel coupling to leaf motor (Diesel)
This is a coupling that allows you to connect the flywheel and clutch on to (Diesel version) On to a Nissan motor output splined shaft.
EV Conversion - Land Rover flywheel coupling to leaf motor (Petrol)
This is a coupling that allows you to connect the flywheel and clutch on to (Petrol version) On to a Nissan motor output splined shaft.
EV Conversion - NSK 6012ZZC3 bearing
NSK 6012ZZC3 bearing Used with the coupling bearings when protecting from pressure of clutch
EV Conversion - Nissan Leaf Gen2 adaptor Plate B (Steel)
This is a plate that can bolt on to a Nissan Leaf Gen2 electric motor Then can connect on to other adaptor plates to build up connect to gear box required Is a steel plate so can use welder to make up own mounts if using as suport
EV Conversion - Drive Shaft clamp lock coupling to leaf motor spline with 1310 shaft profile receiver
This is a coupling that allows you to connect a 1310 shaft On to a Nissan motor output splined shaft. Its allows to be clamped on to the shaft
18 Pin plug (MX23A18SF1) with loom
18 Pin plug (JAE Electronics MX23A18SF1) with 0.4m wiring loom
EV Conversion - Drive Shaft clamp lock coupling to leaf motor spline with 1040 shaft profile receiver
This is a coupling that allows you to connect a 1040 shaft On to a Nissan motor output splined shaft. Its allows to be clamped on to the shaft